Datacom Systems D56 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 72)

–72–

✳ ZN 0 1 B A C K

D O O R

▲

Flashing Cursor if “6” is

pressed (system ready for

next word).

9. Press “6” to accept the selected

word.

NOTE: If these are the only words

you are using for the descriptor,

press “8” instead of “6” to save them

in memory.

10. The two words in our example have

now been entered. Note, however,

that up to three words may be

entered (provided the number of

characters will fit on the screen).

Press “8” to save all words in

memory.

Summary Display

✳ ZN 0 1 B A C K

D O O R

The flashing cursor will disappear,

indicating that the word(s) are stored

in memory for that zone, as shown in

the summary display at the left.

11. To enter a descriptor for the next

zone, press

✱

plus the desired zone

number (e.g.,

✱

02. The summary

display following step 4 previously

will appear. Now repeat steps 6

through 10 for the descriptor for the

next zone.

12. To exit the Alpha descriptor mode,

press “

✱

+0+0” at the summary

display.

P r o g r a m Al p h a ?

0 = No , 1 = Ye s 0

This prompt will be displayed.

A l p h a P g m

8 2

13. Press “0." This will be displayed.

14. Press

✱

99 to exit the programming

mode.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 103 104

Kommentare zu diesen Handbüchern

Keine Kommentare

Datacom Systems D56 Anleitung zur Fehlerbehebung Seite 72

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Datacom Systems D56